PFS PMS and manual boost controller?
01-07-03, 09:45 PM
#1
Full Member
Thread Starter
Join Date: Jun 2002
Location: Del Rio TX
Posts: 247
Likes: 0
Received 0 Likes
on
0 Posts
PFS PMS and manual boost controller?
Do I have to remove my old manual boost controller to use the pms? OR can I just set the manual to 15psi and the work with the pms that way? 
01-08-03, 06:01 AM
#3
development
Originally posted by duboisr
that should work. The pms will only go to 15psi I think, so set it at 14 lbs on the third program.
that should work. The pms will only go to 15psi I think, so set it at 14 lbs on the third program.
01-08-03, 09:00 AM
#4
Passenger
Posts: n/a
Well the way the PMC works is like this. Set the manual boost controller to 10psi so that the boost control maps can work. It will be able to control boost faster and learn it quicker. Also if you get spikes after 3 or 4 pulls open it up to 11-12 psi and you are good to go.
-Rikki
-Rikki
01-08-03, 09:30 PM
#5
Full Member
Thread Starter
Join Date: Jun 2002
Location: Del Rio TX
Posts: 247
Likes: 0
Received 0 Likes
on
0 Posts
I tried that and all three settings stay at 10psi. I even went to 400 menu set prim setting at 10psi, then secondary at 12psi. Tried the switch again same thing, 10psi. How do I change the boost settings?
01-09-03, 09:58 AM
#7
Glug Glug Glug Burp
Join Date: Jan 2002
Location: Scott AFB, IL
Posts: 3,819
Likes: 0
Received 0 Likes
on
0 Posts
Ahh... Rikki's not banned! 
Ryan do you have a writeup on your website? I'm interested in this too, but couldn't find the answer.
*edit* Forgot to ask... Is this with the Manual vent learn on, or off? Thanks!
Ryan do you have a writeup on your website? I'm interested in this too, but couldn't find the answer.
*edit* Forgot to ask... Is this with the Manual vent learn on, or off? Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM