PFS PMC Purple and interacq problem
I have a PFS PMC + remote + original Interacq datalogging and tuning SW
PMC works great remote works great. Add/remove fuel OK Add/remove advance OK RPM limit OK ... I tried to install Interacq with the original disks that I have (I want to do some datalogging and use the refined maps it offers). Install OK when I try to connect, it asks me to insert original disk one. When I do it, it asks me the same thing again after being busy for a few seconds and hearing the disk reader reading the disk. it continues, ever and ever. Did someone had the same behaviour? How do I manage to make it work? Thanks! |
If memory serves right, the disk was only good for one install onto a computer. I have a disk with the same problem and ended up getting a Power FC rather than fight the woes of finding an educated PFS PMC tuner.
|
I agree. Forget data logging. I street tuned mine with the help of a friend watching the controller. Dyno tuning it off the controller's feedback and exhaust sensor is the best you can get with that set up. I also had a peak/low hold 5wire afr gauge that was handy. I loved that computer, but not a lot of support for it out there anymore.
*there is a sub-forum for this over in engine management* |
Thanks. It's les confortable but that's what I do actually.
|
All times are GMT -5. The time now is 11:18 AM. |
© 2024 MH Sub I, LLC dba Internet Brands