I recently installed a Koyo....and a PFS IC. Everything seems to fit good except the IC duct. Has anyone else had problems with the the Duct not being able to fit through the top of the fan shroud? I heard i may have to trim a lil bit off the duct.....but this seems like the opening through the frame and fan shroud is waaay to small. I do have the brackets reversed on the koyo....but its still sittin to high up.

 

I'm pretty sure there's a few members on the board running that setup. I have the Fluidyne, with which you cannot reverse the brackets, so it sits a little higher than stock. The duct is right up against the fan shroud and you have to be careful not to pinch the fan motor wires. It may seem like it won't fit, you have to get it at exactly the right angle.