Tonight I took the pax door panel off to do some work(repaint the interior pieces). I plugged the window switch back to put the window up and it wouldn;t go up! I tried to put it up with the driver's side switch and it didn't work either. The driver's side window works fine. The pax side window worked fine prior to this.

There are 2 wires with ends not connected to anything and I think this is the problem (perhaps got knocked loose or something) but I can't figure out where they go. On the door is a black "box" with 3 sets of screws and wires. The middle set goes to the speaker. The right set of wires (one black, one balck with a white stripe) is the set of wires which has ends not connected to anything. Do any of the electrical wizards know where the wires need to go? Or have any thoughts on this problem?

 

and you're sure it's not just locked from the drivers side?

 

Let it be known that : YOU ARE THE MAN!

that was it! cool - thanks!

 

Don't feel bad. I did this too. I actually went as afr as to take off the door pannel to get at the motor!! It was the lock on the other door. I'm a dumb ***.