anyone have the part number for the K@N airfilter that rob robinette uses.


KN_filters.jpg (42042 bytes)

 

sry bout that

 

hey dude try these, its whats on my car model# RU-0820
here is mine if you just need a reff.

 

thnx man

 

Search under "heat shield template" Damian give your a template and all the K&N part numbers you need. Belive the info is on page 3.

 

yea man no problem hope that helped

 

did you feel a power gain with these filters 7 BOUND?

 

bump

 

Question for you 7 BOUND. Is that a straight section of pipe going from the intercooler to the Greddy elbow or is there a slight bend in it? I have the same set up and I am trying to figure out what to do about getting a pipe to fit in that area.

 

whell is this is the code for the top intake (RU-0820) whats the number for the bottom curved one?

 

i didnt find anything

 

The Summit Racing part number that I was given for the K&N intake filters is KNN-RD-0720. I was under the understanding that they were both the same filters Primary and secondary. If you are referring to the bottom filter as the "curved one," I would say that you need to use the same filter, but curved intake pipe.

Just in case, the air pump filter is KNN-62-1370.

 

I have a M2 cold air filter which uses
two K & N filters, part # RB -0720.
The Length is 6", Width 3 1/2" and
the inner Flange Length is 2 1/2".
I order it striaght from K & N.

 

Heres the link to Damians Heat Shield template with the K&N part numbers you need. You can modify the tempate to fit an ASP intercooler.
https://www.rx7club.com/showthread.p...light=template