3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Oil Control Ring Failure??

Thread Tools
 
Search this Thread
 
Old Jan 15, 2008 | 09:25 PM
  #26  
GoodfellaFD3S's Avatar
Original Gangster/Rotary!
Veteran: Army
Tenured Member: 25 Years
Liked
Loved
iTrader: (213)
 
Joined: Mar 2001
Posts: 30,800
Likes: 646
From: FL-->NJ/NYC again!
Who rebuilt the motor? Was it a first time time attempt? They're easy to get wrong.
Reply
Old Jan 16, 2008 | 02:42 AM
  #27  
grimple1's Avatar
Turd Ferguson
Tenured Member 05 Years
iTrader: (1)
 
Joined: Jul 2006
Posts: 2,047
Likes: 2
From: Sherman Oaks, California
lucky7racing built it. I don't think it was a first attempt. They've got a decent enough rep in the west section. I'm just at an end on what to "fix" .

Does the pcv setup on it sound ok? Capped on the TB and catchcan on the lower nipple (top nipple capped).
Reply
Old Feb 9, 2008 | 09:54 PM
  #28  
Feedthafire's Avatar
sanderson.
Tenured Member 15 Years
iTrader: (7)
 
Joined: Mar 2006
Posts: 774
Likes: 0
From: Va
well i got a motor with about 40 k (mazda reman) on it good compression on the rear rotor a little low but not bad on the front and it was smoking pretty bad i drove it a mile home right before my drive way it cuts off and my exhaust is on fire get out, oil on the ground dripping from left and right side of care still fire inside my exhaust pull my stock int. off oil all in it, UIM oil all in it, oil ALL over the driver side of my motor and car thats far as i got what could this be im still tearing into my motor i think the turbos got 128K on them any ideas?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
FD7KiD
3rd Generation Specific (1993-2002)
15
Feb 26, 2021 10:12 PM
rxmiles
3rd Generation Specific (1993-2002)
9
Aug 24, 2015 02:07 PM




All times are GMT -5. The time now is 11:26 PM.