Hello,
I bought a Nardi wheel on the cheap months ago to replace the stock 93's, and finally got around to opening it up and found out its missing all the wires shown in the write-ups.

Searched through quite a few threads... and did not find any solutions.

Condition:
Pre-2000 Nardi Wheel (Nardi symbol in center)
No Airbag
No wires (at all)
Cut out was made to swap old C/C over.

Goal:
Swap wheel
get horn function
Airbag not necessary - i don't necessary trust a 20yr old airbag anyway.
No airbag light - i read a 2amp resistor will work?


Question:
Is it possible to swap horn and other necessary wiring?
What does the set-up look like?
2amp resistor confirmed to work? another other alternatives?


Thanks in advance.