O2 sensor switching point??
#1
Full Member
Thread Starter
Join Date: Jan 2008
Location: bradenton FL
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
O2 sensor switching point??
Does anyone know the point at which the factory O2 Sensor "switches"?? This is the first rotary that i will be tuning on and i want to replace the factory O2 Sensor with a wide band and i will be using the programable output of the system to replace the factory narrow band sensor. Just wondering if anyone knows at what point they "switch"?? Normally its 14.7.......
#2
RX-7 Bad Ass
iTrader: (55)
Most people ditch the factory O2 sensor when going to the PowerFC. Car actually runs better without it. Not to mention if you use recalc base on the PFC you can't use the O2 sensor feedback.
Also, many widebands don't like going in the factory O2 sensor position. At Fighters we've tried that a few times with different widebands - they overheated and errored out. Best spot for a wideband on the FD is at the end of the factory downpipe.
Dale
Also, many widebands don't like going in the factory O2 sensor position. At Fighters we've tried that a few times with different widebands - they overheated and errored out. Best spot for a wideband on the FD is at the end of the factory downpipe.
Dale
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM