Not the Normal boost problem
#1
Senior Member
Thread Starter
Join Date: Jun 2001
Location: Charleston SC
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
Not the Normal boost problem
OK first I'm familiar with most of the boost problems that the seq system deals out. Up to this point I've lucked out and had no problems, but I guess the evil Seq demons spare no soul. Any way My Primary spools slow and when set to .9 on the PFC never gets there only .7 (10 lbs) or so no matter how high I set the duty cycle. My secondary also set to .9 gets there some times but some times only goes to .83 and sits there.
Mods in Sig below.
Thank for any help
Gary
Mods in Sig below.
Thank for any help
Gary
#3
Senior Member
Thread Starter
Join Date: Jun 2001
Location: Charleston SC
Posts: 252
Likes: 0
Received 0 Likes
on
0 Posts
sorry forgot the vac line job was been done about a year ago. I pulled the uim and checked for loose hoses no such luck. The symtoms don't match the normal run of the mill stuff. Also there are no boost leaks I have all hard pipes and I check all the connectors. The CRV sounds like it's only open right before transtion 4k-4.5k then goes quiet again so I don't thinks it's that, But with a open intake and exhaust I could miss some thing.
Thread
Thread Starter
Forum
Replies
Last Post
82streetracer
Haltech Forum
11
03-11-19 05:34 PM