So I am changing to SS lines and HP+ pads and I am doing the rears first, and when I pulled the calipers, on both rear calipers, there were no v-clips holding the pads off the rotor. In fact, the pads just came right off when I removed the caliper. Is this something that I need to worry about? I dont want to be dragging the rears.

Anyone have a part number for them?

BTW - its a 16MM wrench to roll the caliper back in to fit new pads, FYI I just stuck a screwdriver in the box end of the wrench and rotated the caliper 360 degrees no problem.

Best,

-Jason