no power at some of the fuses
#1
Full Member
Thread Starter
iTrader: (1)
Join Date: Apr 2005
Location: Boston, Mass
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
no power at some of the fuses
been having some electrical issues and im finally getting around to fixing it.
i metered the actual fuse points under the dash, ones im having issues with is wipers, windows, and ignition.
i checked the thick black and blue wire and there is no power there either, ive been looking through some diagrams but cant figure out where the blue and black wire is leading? relay? fuse?
anyone know where this is going too? and where i can find and fix. thanks
i metered the actual fuse points under the dash, ones im having issues with is wipers, windows, and ignition.
i checked the thick black and blue wire and there is no power there either, ive been looking through some diagrams but cant figure out where the blue and black wire is leading? relay? fuse?
anyone know where this is going too? and where i can find and fix. thanks
#3
Full Member
Join Date: Mar 2013
Location: New Zealand
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Hi there,
So the fuse box is missing? Or do you have a relocated battery?
The B2 fuse location can be seen in this post - its the 40A fuse.
https://www.rx7club.com/3rd-generati...l-boot-911028/
The power from B2 does go to the ignition switch (it also receives power from B1) I think fixing the ignition power is the best place to start. I would be checking the thick blue wire with a black tracer and the thick black wire with a green tracer at the ignition. They should both have 12V at all times.
Start there - and otherwise you will need to spend some time reading the wiring diagrams in the FSM.
All the best, Rusty.
So the fuse box is missing? Or do you have a relocated battery?
The B2 fuse location can be seen in this post - its the 40A fuse.
https://www.rx7club.com/3rd-generati...l-boot-911028/
The power from B2 does go to the ignition switch (it also receives power from B1) I think fixing the ignition power is the best place to start. I would be checking the thick blue wire with a black tracer and the thick black wire with a green tracer at the ignition. They should both have 12V at all times.
Start there - and otherwise you will need to spend some time reading the wiring diagrams in the FSM.
All the best, Rusty.
#4
Full Member
Thread Starter
iTrader: (1)
Join Date: Apr 2005
Location: Boston, Mass
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
yes its relocated, also LS swapped. ive had many electrical issues, im honestly looking into buying ISIS 3cell and redoing it all and calling it a beautiful expensive day.
#5
Full Member
Join Date: Mar 2013
Location: New Zealand
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
OK - you are then best to work through each issue systematically - you may be able to solve it without buying something else.
For the wipers - this is quite simple circuit - see page z48 of the link above.
All the best - Rusty
For the wipers - this is quite simple circuit - see page z48 of the link above.
All the best - Rusty
Thread
Thread Starter
Forum
Replies
Last Post
LunchboxSA22
2nd Generation Specific (1986-1992)
37
10-26-15 10:53 AM
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM