No connector running to Fan Switch Sensor
#1
Junior Member
Thread Starter
No connector running to Fan Switch Sensor
Hello everyone!
While removing the water pump housing, I realized there was nothing connected to the fan switch sensor. I traced the wiring harness and utilized the pics/diagrams located throughout the forum and cant seem to locate any loose connectors. Not sure if it was tucked by a previous owner or something else. Fans came on regularly with no issues. Car is a 1992 RHD FD and is currently running an Adaptronic, do I need to rerun something to the sensor for redundancy? Huge thanks in advance to any guidance provided moving forward. This forum has been invaluable to me from the moment I ventured into the FD world.
#2
RX-7 Bad Ass
iTrader: (55)
Read my fan thread for more info on how that system works. There are more than one input, that is only one of the ways that turns the fans on.
That said it's SUPER common for the wire going to the sensor to break off. Is it possible the plug is on the fan switch with the wire broken off?
Pics?
Dale
That said it's SUPER common for the wire going to the sensor to break off. Is it possible the plug is on the fan switch with the wire broken off?
Pics?
Dale
#3
Junior Member
Thread Starter
Dale, thanks a ton man! Great read, definitely cleared a lot up for me. As for the pictures...
Clear sensor
Started removing all the old E tape and stumbled upon this, yikes. Bright side, guess I know where that wire probably is now. Gooood lordy.
Clear sensor
Started removing all the old E tape and stumbled upon this, yikes. Bright side, guess I know where that wire probably is now. Gooood lordy.
Thread
Thread Starter
Forum
Replies
Last Post
RX7TR7
1st Generation Specific (1979-1985)
12
10-06-14 12:30 PM