NICE SOUND with new resonator
#1
DETH TRP
Thread Starter
iTrader: (7)
Join Date: Mar 2004
Location: Manhattan Beach, CA
Posts: 2,544
Likes: 0
Received 0 Likes
on
0 Posts
NICE SOUND with new resonator
I hated the sound of my car after I replaced the Pettit high flow with a midpipe. The car was raspy, backfired a lot; just basically sounded terrible. I wanted my cat back, but with no air pump it wasn't a possibility.
So I decided to go the route I typically do with my decatted cars, install a resonator. But which one? I wanted stainless, with decent length, high flow, but could pass as a high flow cat to a cop of typical intelligence. My choice, a piece from kteller.com.
I decided to go with the compnay after a couple of my friends had good experiences. I was not disappointed. The quality is great, and so is the customer service. It quieted the car down considerably. I was expecting less because of it's small size. Spool time seems the same (I'm non-seq), but noise is greatly reduced, with all raspiness now gone. Don't get me wrong, it's still loud (Apexi duals), but the sound is nice!
3" in/out, 14" long Stainless $65
So I decided to go the route I typically do with my decatted cars, install a resonator. But which one? I wanted stainless, with decent length, high flow, but could pass as a high flow cat to a cop of typical intelligence. My choice, a piece from kteller.com.
I decided to go with the compnay after a couple of my friends had good experiences. I was not disappointed. The quality is great, and so is the customer service. It quieted the car down considerably. I was expecting less because of it's small size. Spool time seems the same (I'm non-seq), but noise is greatly reduced, with all raspiness now gone. Don't get me wrong, it's still loud (Apexi duals), but the sound is nice!
3" in/out, 14" long Stainless $65
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM
83revival
New Member RX-7 Technical
4
09-03-15 10:42 PM