Need Quick help with secondary rail
03-25-06, 03:41 PM
#1
Full Member
Thread Starter
Join Date: Jul 2001
Location: San Diego
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
Need Quick help with secondary rail
ok guys right in the middle of installing extreme fuel system from rotary extreme (Same as kg parts and the rx7store.net kit). Questioin is which of the two wires in the injector plug does the resistor get soldered in on in. THanks guys.
03-25-06, 09:27 PM
#3
Banned. I got OWNED!!!
Join Date: Jul 2004
Location: next to the polishing wheel!!!
Posts: 1,179
Likes: 0
Received 1 Like
on
1 Post
Howard is correct ,I put the resisters above the computor in the car out of harms way ,dirt and heat .The resisters are in the signal wire for easy reference if needed instead of the ground wire . Just the way I thought it worked best .The resisters are mounted on an alum plate that acts as a heat sink .
03-25-06, 10:11 PM
#5
Full Member
Thread Starter
Join Date: Jul 2001
Location: San Diego
Posts: 120
Likes: 0
Received 0 Likes
on
0 Posts
oh ya I messed up on of the push on connectors that go over the wire and then into the plug. I tried to solder it and filled the hole that the prong is supposed to fit in.dumb *** move number 1 of the day. Anyways anybody know where i can get them?
03-26-06, 02:52 PM
#7
Racing Rotary Since 1983
iTrader: (6)
garfinkle..... why are you adding all that excess weight to your car.... aluminum plate for your resistors? and it's on the overworked front tires. yikes. i hope you drilled lots of lightening holes in the plate.
HC
HC
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM