i've recently got everything out that's require to pull my motor and now my motor stuck to my tranny. i have a half inch crack that have been pull but can't get it to come out any farther. does anyone know a good way to pull out the motor? i've tried supporting the tranny with a jack while pulling on my motor.

 

There are 2 inspection plates, one near the slave cyl and the other at the bottom of the tranny. Remove both, push the clutch release fork towards the pressure plate. Use a long screwdriver to push the little "collar" you'll see between the PP and the release fork forward. It should unsnap.

If you don't get that to work you'll need to unbolt the PP from the flywheel, one bolt at a time through the lower inspection plate.

Jeff

 

It will work just be patient.