Like above I need some instructions, but I think I could do it without them. It would be nice though if someone had some

 

The only really hard part is the stupid metal clamps. Replace them with screw down or twist down ones.

It looks worse than it is because of all the hoses, just time consuming. The two holes on left don't need a "L" bracket. The filters do but I only screwed in the left filter because the right one screwed in is too high for the hood rod. If you have a SMIC then the right rear hole will line up. Don't know what the Right middle hole is for.

 

I am having a hard time lining up the holes to screw down the filters. All of those black little L brackets suck. Do you have to screw down both filters?

 

I have a Greddy SMIC, so the heat sheild doesn't line up on two of the holes.

Looking strait at the front of the car: You may have to rotate the bracket "under" the heat sheild to line up the holes and may even have to bend the rear left a bit to start screwing it in.

Since I don't have the R-Front bracket (removed for Greddy)under the heat sheild, that's not screwed in. I only have the left filter srewed down to the heat shield. If I screw down the right filter with the "L" bracket, it sticks up to high for the hood rod.

 

Do I have to screw in both filters? And whats with that big black piece?

 

^