Need help installing M2 harness bar
Thread Starter
Full Member
Joined: Jun 2006
Posts: 85
Likes: 0
From: CINCINNATI
Need help installing M2 harness bar
What size fasteners ar involved.
To remove the rear OE brace, it looks like I have to loosen the nuts to the strut towers. Can I use the original bolts on the strut tower brace or are they too small or short?
While we are fasteners, what are the sizes of the bolts that hold the seat to the floor?
Thank you.
To remove the rear OE brace, it looks like I have to loosen the nuts to the strut towers. Can I use the original bolts on the strut tower brace or are they too small or short?
While we are fasteners, what are the sizes of the bolts that hold the seat to the floor?
Thank you.
Originally Posted by jolly
What size fasteners ar involved.
To remove the rear OE brace, it looks like I have to loosen the nuts to the strut towers. Can I use the original bolts on the strut tower brace or are they too small or short?
While we are fasteners, what are the sizes of the bolts that hold the seat to the floor?
Thank you.
To remove the rear OE brace, it looks like I have to loosen the nuts to the strut towers. Can I use the original bolts on the strut tower brace or are they too small or short?
While we are fasteners, what are the sizes of the bolts that hold the seat to the floor?
Thank you.
The bolts coming up from the strut tower are the studs that come up from the strut top itself. Those 3 nuts are what is holding them (struts) to your car. With the factory top nuts, they are only threaded about 1/2way through from the top, and with the thicker M2 ends, you may need to buy 6 new nuts that are fully threaded.
The bolts that connect the seatrails to the floor are 14mm.
Thread
Thread Starter
Forum
Replies
Last Post