HELP! I just completed the reinstall of my Rotary Resurrection rebuilt engine but I cannot figure out a two plugs?

Plug 1 is near the alternator. Pic 1A is a farther back picture and Pic 1B is a close up of the plug. I suspect that may be my water temp sensor plug but it is far from where it needs to reach.

Plug 2 is a pic from the bottom of the car looking up towards oil filter. This male spade plug comes off the same part of the harness to the starter motor. It is NOT the solenoid plug because that is already on the starter with the power cable. I cannot figure out where this one goes?

Any help is appreciated!

 

plug the 2 of those together, and you have it made!

 

Thanks Oakridge! I did not think they went together since the do not reach each other but I can fix that.

Now if I can only find the temp sender plug since it did not come back from the rebuild attached?