I'm about done with my engine reinstall, and I need a picture of the rear of the engine near the abs unit from above. I have these 2 little brackets, one with a ground strap attached and I can't remember how they go back in.... anybody have a digicam and an fd handy (or a pointer to such a pic)??

Tom

 

is this ok?

 

That is awesome, thanks so much, that covers one of the brackets! Hate to be a pain, but could you take another that covers more of the engine and less of the abs, more from above the area between the firewall and the engine??

Thanks again!!!!

Tom

 

this is the best I have on file. I'm not able to get to a camera just now (really for the next week or so), but I do have a couple pics of the engine out of the car from the backside. What area/bracket are you specifically looking for?

 

here's the backside of my new engine juuuust before sliding it in

Fram filter was for break in only. Just did the 1200 mile oil change and went back to K&N

 

a rotary powered bike...sweet!!

I'm bored ok

 

YAH, though straddling the thing's a bit of a bitch.

0-60 in.. nevermind!!

 

Lots of pics here ... most with high and low res versions ...

https://www.rx7club.com/forum/showth...hreadid=152636

 

You guys rock. What I needed was actually in the first photo after all, just so happened that you had replaced the stock bracket/ground strap in question with that crimped terminal to the rear engine lift bracket, so I couldn't find the OE part in the picture. One of the other shots cleared that right up...

Thanks to all!

gee, I hope this thing starts up... ( I must prepare some fragile object to smash if not!)

Tom

 

Oh yeah, huh. Stock ground strap was replaced with soldered one and star washers and 14 gauge wire.