3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

My baby doesn't want to run i need help

Thread Tools
 
Search this Thread
 
Old Mar 26, 2005 | 05:21 PM
  #1  
bigboz3's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 14
Likes: 0
From: Goldsboro, NC
My baby doesn't want to run i need help

Ok here is the deal my 93 Rx7 went down about a month ago the bacv went bad wouldnt hold itself and some wires broke but now here is my problem got it out last night cruising went good for about 20 minutes shut down at walmart for inspection of motor and that was about it i pulled plugs they were oil fowled and flooded so cleaned them up blew the holes out and got it running good for about a min or min and a halfthen it quit again this morn had quicking off for real short sperts when i was holdin my hand were the air filter goes blocking its air flow it has an apexi powerfc a single t66 garret turbo 3 inch down pipe no cats I am stuck now don't know what to do next any advise would be very helpful thanx
Reply
Old Mar 26, 2005 | 06:58 PM
  #2  
tt2323's Avatar
Import Connoisseur
Tenured Member 15 Years
 
Joined: Oct 2003
Posts: 1,335
Likes: 1
From: All over the place
Could you reiterate that? I'm sorta confused i'm sure as others what is the exact problem you experiencing
Reply
Old Mar 26, 2005 | 09:38 PM
  #3  
bigboz3's Avatar
Thread Starter
Junior Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 14
Likes: 0
From: Goldsboro, NC
aight sorry i can start the car for a few seconds with my hand blocking the air flow over the air cleaner hose but as soon as i released it the motor would quit as of this moment it will not even do that much i have fuel fire and compression in the motor not sure were to go next
Reply
Old Mar 26, 2005 | 11:34 PM
  #4  
93FD3S's Avatar
Big Snail
Tenured Member 05 Years
 
Joined: Dec 2001
Posts: 1,230
Likes: 3
From: San Antonio
Large vacuum leak. Check intake manifold gaskets especially the lower intake manifold gasket. Its probably the paper version. Also check all your vacuum lines. You can use the old carb cleaner trick, by spraying it around the motor to determine where the leak is coming from.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Tylerx7fb
1st Generation Specific (1979-1985)
39
May 27, 2019 12:45 PM
thecody59
1st Generation Specific (1979-1985)
40
Aug 23, 2015 06:41 PM
Frisky Arab
2nd Generation Specific (1986-1992)
13
Aug 18, 2015 05:30 PM
smikels
2nd Generation Specific (1986-1992)
3
Aug 18, 2015 01:26 PM




All times are GMT -5. The time now is 02:12 PM.