More on LM-1 and LMA-2
#1
Senior Member
Thread Starter
More on LM-1 and LMA-2
Ok before anyone askes i have searched but not a lot of info around on LM-1 wideband and RX7 at the mo .
What values has eveyone set thair LMA-2 RPM converter to.
channel 1 is RMP : set to rotary of corse (rpm)
channel 2 is Boost : set to -19.30 = 0 volts and 18.60 to 5 volts (psi)
channel 3 is TPS :set to -33.0 = 0 volts and 100 = 5 volts (mesure)
channel 4 is nothing
channel 5 is nothing
Need to fine tune things as max boost on the PFC and AVC-R is showing 8.1 bar or 11.7 psi but LMA-2 is showing max boost to be 0.95 bar or 13.9psi so im assuming the LMA-2 calculations are out a little.
Whats everyone using for these conversions or anyother channels loging anything else.
What values has eveyone set thair LMA-2 RPM converter to.
channel 1 is RMP : set to rotary of corse (rpm)
channel 2 is Boost : set to -19.30 = 0 volts and 18.60 to 5 volts (psi)
channel 3 is TPS :set to -33.0 = 0 volts and 100 = 5 volts (mesure)
channel 4 is nothing
channel 5 is nothing
Need to fine tune things as max boost on the PFC and AVC-R is showing 8.1 bar or 11.7 psi but LMA-2 is showing max boost to be 0.95 bar or 13.9psi so im assuming the LMA-2 calculations are out a little.
Whats everyone using for these conversions or anyother channels loging anything else.
Thread
Thread Starter
Forum
Replies
Last Post
Dan_s_young
General Rotary Tech Support
6
08-14-06 06:39 PM