Modified engine bay for FMIC back to stock.
#1
Modified engine bay for FMIC back to stock.
I picked up a roller a couple months ago and the previous owner had a Greddy FMIC installed at one time. Therefore, the sway bar brackets were modified along with the condenser and a few other things.
I installed a Greddy FMIC on my last FD, but it's been over 5 years ago now and I can't remember what I had to hack up or modify to do so.
I'm wanting to put my roller back to stock with an aftermarket smic and the radiator sitting in the factory v-mount position. Besides new sway bar mounts, what else do I need to do?
I installed a Greddy FMIC on my last FD, but it's been over 5 years ago now and I can't remember what I had to hack up or modify to do so.
I'm wanting to put my roller back to stock with an aftermarket smic and the radiator sitting in the factory v-mount position. Besides new sway bar mounts, what else do I need to do?
#2
Only thing I remember doing for my greddy 3 row install was drilling 2 holes in each of the bottem brackets. That and you had to cut a piece of metal so the hotside piping would fit. You should be able to go back to stock easily.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM