ok after installing my master and slave cylinder ...my meters is not working after the install... i have checked all the fuses in the (inside) interior panel .. all fuses seem to be good.. the gauges were working fine before the install ..... if anyone out there have been through this problem please drop a few comments on what you think it is .... i havent got the chance to check the harness behind the cluster also so that might can be the problem which i doubt .... my mileage,rpm,speedo,temp,oil is not currently working, gas meter still shows gas level so im assuming it still works..none of the light on the cluster dont work also so im assuming theres no power at all throught the cluster ... any help will do, thanks guys

 

check the 15amp meter fuse in the engine bay.

 

15A Meter fuse definitely. Although I could've sworn it was in the fuse box near the driver's side kick panel.

It will probably blow again, the Meter fuse doesn't blow for no reason. Mine was caused by a short in the wiring for the air pump.

The Meter fuse is a very important one, without it the e-fans will not come on, the gauges won't work, air pump won't work, I believe even the reverse lights and turn signals don't work either.

 

i have check all the fuses in the driver side kick panel, everythiing is tested good ... and my signals and reverse lights are still working ...but i will check the fuse in the engine bay .... any other comments would help also, thanks guys

 

ok have checked in the engine bay for the 15a meter fuse, i dont see 15a meter anywhere in the engine bay area ....if so can someone verify where its located

 

have check the driver kick panel, METER fuse 15a is still good, my next option would be checking harness behind

 

I'm guessing you dislodged a connector while working on the master/slave.