Map Sensor Voltage
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2005
Location: NV
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
Map Sensor Voltage
After having a vacuum problem for a while now I decided to check the voltage at the MAP sensor as per the FSM instructions. I came out with a reading of 4.96V at idle and the FSM says it should be from 1.3V to 1.5V. So does this mean that my MAP sensor is toast or could something else cause these readings and my typical vac at idle is 13-14ish. Sometimes a bit lower on a hot start. Any help would be appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM