Map Sensor 3-Bar problem
#1
Full Member
Thread Starter
Join Date: Feb 2002
Location: Texas
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Map Sensor 3-Bar problem
Hooked it up. Had to cut slots w/ a dremel to make the harness fit the sensor.
Went to start the car and it read 1.19 bar and would not start. I am assuming if dumped a ton of fuel with that reading.
I followed the ABC connections posted. Any suggestions?
Went to start the car and it read 1.19 bar and would not start. I am assuming if dumped a ton of fuel with that reading.
I followed the ABC connections posted. Any suggestions?
Last edited by Ehughes; 01-11-05 at 02:58 PM. Reason: typo
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Microtech
3
08-22-15 05:52 PM