Manual Boost controller
#1
Full Member
Thread Starter
Join Date: Mar 2002
Location: Arlington, TX
Posts: 168
Likes: 0
Received 0 Likes
on
0 Posts
Manual Boost controller
Hmm, hooked it up the way it said to (simple Joe P) and I build boost to 0 psi and then no more. Just went non sequential, dunno if I did it right. Basically, I wired open the secondary flapper, unhooked the pre-control, capped one of the nipples directly off of the primary turbo and used the other one to go to the boost controller and capped the other end of the wastegate. Also ran a vacuum hose from the CRV/ 2nd BOV to the Y-pipe nipple. So if anybody knows how to hook up a manual BC or has gone non SQ I would appreciate some info.
Thanks
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM