Manual Boost Controller
#1
Full Member
Thread Starter
Join Date: May 2002
Location: Irvine, CA
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
Manual Boost Controller
I'm getting two of these manual boost controllers.
Which end goes to the housing, the end opposite of the **** or the end that faces down (perpendicular to the ****)?
Anyone have good success with these controllers? I know there are cheaper ones on eBay but I like the anodized look and I'm going to use a red and a blue one so I can easily tell the difference between the boost controller and pre-controller.
Which end goes to the housing, the end opposite of the **** or the end that faces down (perpendicular to the ****)?
Anyone have good success with these controllers? I know there are cheaper ones on eBay but I like the anodized look and I'm going to use a red and a blue one so I can easily tell the difference between the boost controller and pre-controller.
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM