Ok. I have searched, but cannot find a straight answer to my ?. will a manual boost controller tie in the same way if you are running non-seq(poor mans) set-up? Or is there somwhere else I need to tie in to. I am following Rob Robinetts mbc installation instructions. If they are the same with a seq. setup as the non seq setup than I am good to go .. ... right? Btw its a Voodoo boost controller that I purchased online. Thanks

Manny

 

It will be inserted into the line between the primary turbo housing and the wastegate actuator, whether or not you are seq or non-seq.

 

Thanks Rynberg.