3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Location for starter cut relay?

Old Jan 23, 2005 | 06:37 PM
  #1  
tubolove's Avatar
Thread Starter
tubolove
Tenured Member 15 Years
 
Joined: Aug 2004
Posts: 19
Likes: 1
From: Florida
Location for starter cut relay?

Before I tear apart the dash, can anyone tell me the location of this relay? Have intermittent starting problem on a '94 R2 and everything else checks out fine. Not sure if its the Power FC or the relay itself!

Thanks in advance.
Reply
Old Jan 24, 2005 | 10:32 AM
  #2  
wolf7676's Avatar
Full Member
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 64
Likes: 0
From: Hollywood, FL
I think it is down by the kick panel on the drivers side. I am not positive though. what does yours do when it tries to start? I also have a 94' r2 and after sitting for a week or so, I try to start it and the dash lights come on but no clicking from the starter and the radio lights up for a second and then turns off. I have to keep turing it over about 8 times before it final clicks over???? Battery terminals are new and clean? Not sure what else to look for? Maybe we have the same problem?
Reply
Old Jan 25, 2005 | 09:05 PM
  #3  
tubolove's Avatar
Thread Starter
tubolove
Tenured Member 15 Years
 
Joined: Aug 2004
Posts: 19
Likes: 1
From: Florida
Since I put in the Power FC, the car will not start from time to time. I have battery power at the starter, but no power at the starter from the ign. switch, no power through the interlock switch. The only thing left is the starter cut relay which is either bad, OR not getting the ground signal from the ECU. Need to test it to be sure.
Reply
Old Jan 27, 2005 | 11:45 AM
  #4  
FL_94R2's Avatar
Newbie
 
Joined: Jan 2004
Posts: 4
Likes: 0
From: FL
Had the same no start problem a while back although it occurred more often than "from time to time". Like you, narrowed problem down to the starter cut relay or the alarm ECU. Note that this is not the main ECU controlling this relay. Since it was cheap I replaced the relay but it didn't resolve the problem. Alarm ECU was too costly to justify so I just jumpered the relay out of the starting circuit and have had no problems since
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Boriquaguerrero
2nd Generation Specific (1986-1992)
20
Apr 22, 2019 01:15 PM
The Shaolin
2nd Generation Specific (1986-1992)
9
Sep 14, 2015 07:50 PM
befarrer
2nd Generation Specific (1986-1992)
4
Aug 14, 2015 04:18 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 01:08 PM.