Knock Sensor Shielding
#1
Full Member
Thread Starter
Knock Sensor Shielding
Previous owner had a fire in the car and the harness was repaired, the repair switched the knock sensor and power steering connectors. Switching back isn't possible as the repair made the distance between sensor and socket too big.
I'm looking to repair it properly and run new wire, I understand that the wire is shielded, but can't find if the shield is actually connected to anything? (I'd assume GND somewhere in the loom?) I know the "sensor end" of the wire, just has a 1 pin connector, and there is only one pin for knock sensor on the ECU
In short, where do I connect the shield for the knock sensor?
I'm looking to repair it properly and run new wire, I understand that the wire is shielded, but can't find if the shield is actually connected to anything? (I'd assume GND somewhere in the loom?) I know the "sensor end" of the wire, just has a 1 pin connector, and there is only one pin for knock sensor on the ECU
In short, where do I connect the shield for the knock sensor?
The following users liked this post:
b3delta (03-27-20)
Thread
Thread Starter
Forum
Replies
Last Post