Idle issue with brake applied
#1
Senior Member
Thread Starter
iTrader: (2)
Join Date: Jun 2003
Location: Pittsburgh
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
Idle issue with brake applied
After the car has warmed up I get an erratic idle and my vacuum drops and jumps between 10-12Hg when the brakes are applied and it runs very rich. If I let off the brakes the idle will return to normal after a few seconds. Sadly this has been going on for awhile and a year ago I tested the brake sensor under the dash and it appeared ok. I'll test it again but I have a suspicion that it will be fine at least according to the specs in the shop manual. I need to check again to see if it only does it when there is an electrical load but I know it's worse when the AC is on.
Any other ideas of what to check?
I have been looking for this problem for a couple years now and honestly am at a lost. I am guessing it is electrical since that will be the most difficult thing for me to figure out.
Thanks
Any other ideas of what to check?
I have been looking for this problem for a couple years now and honestly am at a lost. I am guessing it is electrical since that will be the most difficult thing for me to figure out.
Thanks
#3
Senior Member
Thread Starter
iTrader: (2)
Join Date: Jun 2003
Location: Pittsburgh
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Mahjik
Did you do a check on the check valve for the brake booster?
I haven't checked it since I ran all new hoses a few years ago. I'll check again.
#4
What's your point ?
Join Date: Feb 2001
Location: Gainesville, Fla.
Posts: 3,573
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by arutha
I haven't checked it since I ran all new hoses a few years ago. I'll check again.
Did this problem start right after you did the hoses ? ? ? I didn't realize there was a one way check valve in the rubber hose from the brake power booster to the metal line on the fire wall and had a weird idle, and strange things under boost and when I went to stop. If you changed that hose and don't have the check valve in there this could be your problem.
Thread
Thread Starter
Forum
Replies
Last Post
diabolical1
2nd Generation Specific (1986-1992)
30
01-30-16 05:50 AM
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM