IAC plug came off
#1
Rotary Enthusiast
Thread Starter
IAC plug came off
I am sorry guys for the ignorance. I am looking up multiple threads and old pics, but can't confirm wire positioning. I want to confirm the big black wire goes on the right side looking at the top of the plug.
Top of the plug is side with the actual clip.
Can someone take a few and explain looking at a wire harness the proper way to see order of wires. I assume it is always looking at the top of the plug, but would like to confirm as you know what they say about assumptions!!!
Top of the plug is side with the actual clip.
Can someone take a few and explain looking at a wire harness the proper way to see order of wires. I assume it is always looking at the top of the plug, but would like to confirm as you know what they say about assumptions!!!
#2
Rotary Enthusiast
Thread Starter
Never mind. Sorry for the waste of space with this thread... total brain lapse. Looking at the front of plug clip on top B/W goes on the right... or in on the left from behind.
#3
RX-7 Bad Ass
iTrader: (55)
It doesn't matter, it's just 12v and ground, it works the same no matter the polarity. But it's worth putting it in right per the shop manual
Dale
Dale
#4
Rotary Enthusiast
Thread Starter
I am hoping these solenoids I replaced (all of them) fix my primary boost issue. After testing if all is well... this UIM will come back off as I am staring at my new 1300x ID secondaries!!!
I appreciate the quick response!!
Thread
Thread Starter
Forum
Replies
Last Post
DomFD3S
2nd Generation Specific (1986-1992)
5
10-28-02 04:03 PM