Ben93RX7

i did a search and couldnt find anything... i have heard u have to kinda ghetto wire them (since the harness is different)...

How do u do this??? any instructions anywhere???

Herblenny

iTrader: (13)

I have 99 spec combo lights and trying to figure this out.. i haven't installed it yet.. but I heard you could just used general electrical connector (slide type) to connect it.. I been looking for jdm harness from japan and no luck so far..

sub-zero

I just finished this and here is what I did.

I ordered very small slide on pin conectors from a computer store. You will have to cut the factory clips off and crimp/solder these new small pins on. the only problem is that You will have to use some electrical tape to make sure they do not touch. I also noticed if You grind off the tabs You can use the original turn bulb and socket as it fits nice and snug, this way You could use the factory socket and plug. I had these in last year without hooking them up but they look great now. I used the amber for the driving light. I am sure there are lots of Guys that dont have these hooked up.

SpiritR

Check out this, 99spec adapters so I guess its just plug and play..

http://www.jt-imports.com/Border_99_spec_adapters.jpg