I blew my PFC due to a bad harness, so now that the harness is about to get installed. I want to block off anything that is not neccessary in the LIM/UIM area. The rats nest has already been eliminated but after searching I am still not certain what is safe to remove with a PFC installed. If only someone could make a how to with pics...

 

You can remove anything that you don't intend to use. The PFC will not trip the check engine light. One can't post a "how to" on what you specifically want to do with your manifolds. Just about every elimination mod has been covered before on the forums if you look back some. Again you need to decide what you want to get rid of.

 

I'm just looking for a little guidance. A few pics of what was removed/capped would help out alot.

 

what is the set-up are you running? single? non- seq? or stock? I just did a single conversion here's the thread:
https://www.rx7club.com/single-turbo-rx-7s-23/question-fpr-solenoid-671882/

just read the whole thing it might give you a good idea what to do.

 

I'm running stock twins on a street port, non sequencial, no rats nest, no air pump..PFC equipped

 

Is there any other way?

 

another quick(maybe stupid) question, are gaskets required on the block off plates?

 

Just use some RTV.