-of each size- do I need for non-sequentials with the smog pump?

I've seen the kits for $300 but since I don't need most of that line I'd rather buy ala carte.

 

I would get half the lengths of the kits for 3rd gens. Even with that you'll have some left over in the 3.5mm and 4.0mm sizes.

Dave

 

I bought 10feet of 3.5mm and 10feet of 4.0mm for my non-sequential and ended up with left over. I'd much rather have to much then not enough. 300$ for a kit wow how many feet do they give you? The place i order from is .97$ a foot or for magnum silicone it's 1.07$ a foot.

 

Did you keep any emissions gear?

I don't recall the place I looked, it was referenced in one of the writeups.

 

No full none seq without emissions. I ended up with only the like 3-4' of 3.5mm left over i used the 4.0mm way more. If i did it again i'd probably go 15-20' of 4.0mm. Also i did screw up a few times and cut pieces to short and had to toss them.

 

i just did mine to full stock setup
I ordered 40 feet of 4mm and 15 feet of 6 mm.
By the time you test all the solenoids and actuators you end up using a little more but you would still have a few feet left over. I could probably get away with a lot less hose if i had to do it a second time but its always good to have a little extra