How the heck do u pull the stock bulb out? ASAP
#1
Rotary Enthusiast
Thread Starter
How the heck do u pull the stock bulb out? ASAP
I just got my headlight assembley apart but I Cant figure out how to pull teh actual bulb out!!!, I dont wannause force and break somthing. pls help ASAP
#6
Belligerent MoFo
OK, I'm trying to do the same... let me see if I have this straight.
I'm at the point were I can access the connection to the bulb. The bulb is inside this black rubber sleeve (hahaha).
Now, I need to remove the black sleeve. How?
Pull the bulb out? Any turning? Mine was in there pretty tight and I didn't want to force it out.
Any comments would be appreciated.
Thanks,
Victor
I'm at the point were I can access the connection to the bulb. The bulb is inside this black rubber sleeve (hahaha).
Now, I need to remove the black sleeve. How?
Pull the bulb out? Any turning? Mine was in there pretty tight and I didn't want to force it out.
Any comments would be appreciated.
Thanks,
Victor
#7
Rotary Enthusiast
Thread Starter
hey haha, you pull the rubber boot off, and then there is a metal rod type thing holding the bulb in place. its hooked in on one side and screwed down on the other. Once you remove this backing piece the bulb will come right out.
Trending Topics
#9
Belligerent MoFo
I looked and looked and this is the most complete answer I found. I just needed that last little bit about the backing piece... now I won't break it.
Thanks,
Victor
Call me the resurrector
hahaha I said rector
Thanks,
Victor
Call me the resurrector
hahaha I said rector
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM