how do u remove the primary injectors from the fuel rail??
Thread Starter
Joined: Feb 2001
Posts: 2,634
Likes: 2
From: Sicklerville, South Jersey!!
how do u remove the primary injectors from the fuel rail??
ok i got the rail out to send them to rc to get cleaned and stuff...but how do i get them out of the rail..or do i just send the whole deal to rc and theyll take care of it??
thanks
thanks
I think if i recall there are two screw's that hold the injector holder. Then u removed the holder and the injector with a little force. Also make u mark each injector because rc do not do it for u.good luck
It's never fast enough...
Joined: Feb 2001
Posts: 3,760
Likes: 3
From: Miami - Given 1st place as the POOREST city in the US as per the federal government
You need to twist them back and forth and pull them slowly out. Try applying some 2-cycle oil into the o-rings or spraying some WD40 on it. This should help loosen em up a bit. They injectors are always VERY tight on there.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM