hot start and idling issue
#1
Full Member
Thread Starter
Join Date: Mar 2008
Location: edmonton
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
hot start and idling issue
My fd has problems. It starts fine when cold, and also idles fine. Once warmed up I have a very erratic idle, anywhere from 600rpm to 1500rpm and usually will stall when coasting to a stop or when my foot is off the throttle. Also it WONT hot start.... at all, I have to wait at least ten min before it will even think of coming close to starting again. I changed my fuel filter yesterday, found my fuel pressure was at 25 so I set it at 35(dunno if thats correct), and took out my IAC and brake cleaned the **** out of it. I haven't had any fun in it at all this summer, so any help i get is greatly appreciated!
#5
Full Member
Thread Starter
Join Date: Mar 2008
Location: edmonton
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
3mm Apex Seals
Braided Oil Metering Pump Lines
Walboro In-Tank Fuel Pump
Fuel Pump Relay
1600cc Secondary Injectors
550cc Primary Injectors
Sard Fuel Pressure Regulator
Fuel Pulse Dampener
Electrical System
New Wiring Harness
New Spark Plugs
New Spark Plug Wires
Optima Battery
Single Turbo Conversion
Koyo Radiator
Greddy 2-Rom Front Mount Intercooler
Greddy Elbow
Greddy Type RS Blow-Off Valve
Tial 38mm Wastegate
T04R Single Turbo
Power FC and Commander
Megan Racing Stainless Turbo Manifold
3 Inch Exhaust
New Vacuum Lines
Haven't been able to get ahold of a decent compression tester yet, and im really hopeing I don't.
Braided Oil Metering Pump Lines
Walboro In-Tank Fuel Pump
Fuel Pump Relay
1600cc Secondary Injectors
550cc Primary Injectors
Sard Fuel Pressure Regulator
Fuel Pulse Dampener
Electrical System
New Wiring Harness
New Spark Plugs
New Spark Plug Wires
Optima Battery
Single Turbo Conversion
Koyo Radiator
Greddy 2-Rom Front Mount Intercooler
Greddy Elbow
Greddy Type RS Blow-Off Valve
Tial 38mm Wastegate
T04R Single Turbo
Power FC and Commander
Megan Racing Stainless Turbo Manifold
3 Inch Exhaust
New Vacuum Lines
Haven't been able to get ahold of a decent compression tester yet, and im really hopeing I don't.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
82streetracer
Haltech Forum
11
03-11-19 05:34 PM