HKS 'Compound Meter' Boost Gauge Wiring
#1
HKS 'Compound Meter' Boost Gauge Wiring
Not strictly FD related, but I though some people here may have this installed since it matches the FD interior pretty well.
I can't figure out the wiring on this and the manual I have is in Japanese. The gauge has four input wires (pictured below). Black and red are power and orange is backlighting but I can't figure out what the yellow line is for.
Here is a scan of the manual for those who may be able to read Japanese:link.
TIA
I can't figure out the wiring on this and the manual I have is in Japanese. The gauge has four input wires (pictured below). Black and red are power and orange is backlighting but I can't figure out what the yellow line is for.
Here is a scan of the manual for those who may be able to read Japanese:link.
TIA
Last edited by moconnor; 01-02-07 at 01:39 PM.
#3
RX-7 Bad Ass
iTrader: (55)
Call HKS up - they're VERY friendly and knowledgeable, and I've gotten quick answers to questions like this on older products.
That said, it's most likely similar to the Greddy gauges - hot power, switched power, illumination, and ground. You might be able to find them with process of elimination - hook up ground and give 12v to all 3 wires. One wire, if you remove 12v, should make the illumination go off, etc.
Dale
That said, it's most likely similar to the Greddy gauges - hot power, switched power, illumination, and ground. You might be able to find them with process of elimination - hook up ground and give 12v to all 3 wires. One wire, if you remove 12v, should make the illumination go off, etc.
Dale
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM