high boost sequential pattern?
#26
Eats, Sleeps, Dreams Rotary
iTrader: (17)
I have Greddy ebc and not familiar with the KS, but I can't imagine any aftermarket boost controller working the same "way" the stock does! Any ebc I have seen actually measures the boost and controls accordingly. . .the stock system does not do this. I tried staying with the stock boost system way to long -- go to ebc if you want reliable control.
--Jeff
--Jeff
well it connects to the stock ecu harness and takes control over the oem (or pfc) boost control, no external boost control solenoid.
but you got a good point about the feedback operation to maintain boost instead of the duty cycle like the pfc does... i might put it back and try how it does.
Last edited by neit_jnf; 12-06-08 at 12:43 PM.
#27
SideWayZ The Only Way
iTrader: (11)
Lots of good comments in this thread. Very few know how to tune the transition using datalogit (I'm not expert but have played with it a lot) and you can do amazing things with that tuning. Comment to Stix -- with the BNR's I found the primary is soo strong i actually moved the transition up rather than down so that I have full/quick primary response longer and it doesn't bring on secondary until you really need it. BNR primary has no problem going 15+ up to a good 4-5k. Sorry, hard to explain some of this clearly. . .
--Jeff
--Jeff
#28
400Rwhp Seq Twins Baby!!
Join Date: Mar 2006
Location: "Sunny" ol England
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
So how does one tune the transition??
After mine was tuned it had 14.5-13.7-14.5 with just a flick on the boost gauge...Buuut then the engine blew
After mine was tuned it had 14.5-13.7-14.5 with just a flick on the boost gauge...Buuut then the engine blew
Last edited by Rixio_Scon; 12-06-08 at 04:20 PM.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
rx8volks
Canadian Forum
0
09-01-15 10:46 PM