Help wiring
#1
Senior Member
Thread Starter
Join Date: May 2004
Location: Nor Cal
Posts: 251
Likes: 0
Received 0 Likes
on
0 Posts
Help wiring
I got a water temp. gauge because the stock ones blow. But I can seem to find a place on the fd where I could hook it up to ignition switch. Which one is the ignition switch, where is it?
I am new to the fd world it would help if you had pics or detailed direction.
thanks
I am new to the fd world it would help if you had pics or detailed direction.
thanks
#2
Slam Pig
Join Date: Dec 2002
Location: New York
Posts: 888
Likes: 0
Received 0 Likes
on
0 Posts
Heres what I use when wiring my car
http://www.apexi-usa.com/documentation.asp
Ok now i know your thing isnt an apexi anything BUT if you get the following pdf
http://www.apexi-usa.com/productdocu...savcr_wire.pdf
picture at the bottom Z3-b (i think thats it, double check) has all the wires which you will need when wiring up stuff....
also plan ahead on this one (gauges and what not) will all need ign power....heres what I did
Get some vampire clamps from autozone/advanced auto parts and clamp in a new line parallel to your old ign line...this is so you have plenty of line to tap into while also not screwing with your finicky wire harness....
http://www.apexi-usa.com/documentation.asp
Ok now i know your thing isnt an apexi anything BUT if you get the following pdf
http://www.apexi-usa.com/productdocu...savcr_wire.pdf
picture at the bottom Z3-b (i think thats it, double check) has all the wires which you will need when wiring up stuff....
also plan ahead on this one (gauges and what not) will all need ign power....heres what I did
Get some vampire clamps from autozone/advanced auto parts and clamp in a new line parallel to your old ign line...this is so you have plenty of line to tap into while also not screwing with your finicky wire harness....
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM