HELP ! trying to narrow down my boost problem
HELP ! trying to narrow down my boost problem
ok so after 2 years its up and running again with full exhaust and aggressive ported reman... no other mods and a pfc on the way
Im not trying to beat on it but the couple of times i got on it to see if it was boosting correctly it sometimes will reach 5lbs, iand when it hits 5 lbs it seems the second turbo will whistle but no boost
what could eb causing this ??? I do have an exhaust leak somewhere (havent pinpointed it yet) could that be the cause ?
any suggestions...
THanks,
Scott
Im not trying to beat on it but the couple of times i got on it to see if it was boosting correctly it sometimes will reach 5lbs, iand when it hits 5 lbs it seems the second turbo will whistle but no boost
what could eb causing this ??? I do have an exhaust leak somewhere (havent pinpointed it yet) could that be the cause ?
any suggestions...
THanks,
Scott
No, exhaust leaks won't cause boost problems. They will make for a ricey sound, but that's about all.
The whistle may be coming from one of the intake piping couplers - remove the 2.5" rubber couplers, roll them around in your fingers to try and reveal any cracks or cuts. Also turn them inside out and repeat. Check every one between the y-pipe and throttle body elbow. Make sure you don't overtighten any band clamps or else the pinching action will cause tears.
Dave
The whistle may be coming from one of the intake piping couplers - remove the 2.5" rubber couplers, roll them around in your fingers to try and reveal any cracks or cuts. Also turn them inside out and repeat. Check every one between the y-pipe and throttle body elbow. Make sure you don't overtighten any band clamps or else the pinching action will cause tears.
Dave
Also make sure you have the Y-pipe flanges bolted up tight to the turbo housing. Being as you experience noise with the secondary turbo, check those flange bolts (the ones to the rear end of the Y-pipe) especially close. These are hard to see and you may need to remove the input piping to see them clearly.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
Mar 15, 2022 12:04 PM
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM
AXA
Single Turbo RX-7's
8
Sep 5, 2015 10:06 AM
tiger18
3rd Generation Specific (1993-2002)
9
Sep 3, 2015 08:27 PM





