Help! I turn the key and nothing happens....
#1
Junior Member
Thread Starter
Join Date: Dec 2008
Location: Searcy, AR
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
Help! I turn the key and nothing happens....
I'm currently in the process of an auto to manual swap. The car came with a manual wire harness installed before i took over the project. The starter tested good, the neutral switch is plugged up, all fuses good, manual ecu in place, but i dont have any connections for the clutch switch. I think if i could just get the clutch switch figured out the car would turn, but i cant so i'm stuck.
If i still had the auto wire harness i would be okay because everyone keeps theirs when they swap and they tell about it, but the previous owner who started the project swapped it over and apparently didn't finish the job.
Any input would be greatly appreciated.
If i still had the auto wire harness i would be okay because everyone keeps theirs when they swap and they tell about it, but the previous owner who started the project swapped it over and apparently didn't finish the job.
Any input would be greatly appreciated.
#2
Junior Member
Thread Starter
Join Date: Dec 2008
Location: Searcy, AR
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
1st Generation Specific (1979-1985)
7
09-18-15 07:13 PM