ek9220ps

iTrader: (4)

my car runs like crap.. i was messing with the timing map and i think i change too much... please help.. i can't
even drive my car.

anyone have a base tuned maps .. i had a XS Base map.

SpeedracerRX7

All you need to do is to go into the ETC. function at the main menu and re-initiate the data. This returns the PFC back to its base maps. After doing this you will have to let it do the idle bounce and all for 20 min again but it should get rid of your problems. That should at least get it driving around again at 10 psi but don't push it until you get a tuned map in it. Good luck.

evot23

iTrader: (17)

Or go to the PFC thread, download a base map and plug in the values. Obviously easier with the datalogit.

Sled Driver

iTrader: (9)

Did you happen to notice that there is a section in the Forum titled
"ECU Forum - Power FC / Haltech / AEM"

From there you can select "Power FC Maps + Intsructions "

Here is a handy link to help you along....

https://www.rx7club.com/forum/showth...threadid=10509

Good luck

Import Convert

Why the hell would you even mess with it if you-
1) Already had a tuned map in it
2) don't know what the hell you are doing

If you don't know exactly what you are doing it would be best to leave it alone.

ek9220ps

iTrader: (4)

after i install my hks twin power i was getting high knock level like 130 max.. so i started to play around adding fuel and stuff. and i got it down but it was still too high. so i took a couple degree off of the timing. that help alot. but when i down shift and brake the knocks was still too high. and than i wanted to copy my friend maps is i change both the igl and igt. i shouldn't of copy him maps i know.