well i just got my harness back but its been so long i dont knwo where it lays ... is there any diagram or pictures yall guys have around the engine bay so i can take a close look on where everything lays, connectors and ect is most likely simple to connect .... all i need is just clear pictures around the engine bay, (harness area) both sides , chassis and motor , also a diagram will work ... i have got it modify'd to remove and cliped whats not needed... thanks guys

 

Here's a thread about the harness routing:

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/wiring-harness-routing-531829/

Here are the colors for the solenoids:

https://www.rx7club.com/showpost.php...03&postcount=3

Other than that, the only other real hiccups are the thermosensors. There are two of them: Fuel and Coolant

The sensors are the same, but in two different locations. The connectors will reach to either. You should verify the proper ones using the wiring diagram. IIRC, the coolant thermosensor will have a G/W or a G/Y wire, but verify the proper wire colors with the wiring diagram.

 

thanks for the info ....

i also need pictures where the battery harness is located and that area ...

 

 

thanks ... thats what i needed ....