i'm going to tap my stock fuel rails to eliminate the crappy hosing that mazda installed

has anyone done this? can anyone supply me with a parts list and/or tap sizes?

i'm mainly interesting in tapping the primary->secondary ports

i've searched and searched, please help!

 

Garfinkle makes new end parts for the pri fuel rail that has 3/8 steel lines comming out where they need to be for his set up . the new end parts have two or three O rings on each end . The flat part is thicker than stock and is held on with allen head screws . the stock bore of the rail was drilled out bigger as well .The fuel pressure damper is gone . All of his gas lines are custom made with no 90 degree elbows, and 3/8 air craft tubing from the pump to the fuel pressure regulator . The stock rails can be tapped but the method he used did not leave the alum casting thin or weak .

 

price? turnaround time? pics?

 

Pm Rotorbrain and ask for picts . Call Garfinkle if you like the picts and see if the set up can help you .

 

yeah, i'm just thinking i can find adapters/banjos for the secondary and tap the fuel rail on the primary, shouldn't be hard...