Guage Cluster has power/light but no signal to guages???
10-24-04, 10:53 PM
#3
Eats, Sleeps, Dreams Rotary
iTrader: (4)
Join Date: Apr 2003
Location: Denver, NC
Posts: 3,531
Likes: 0
Received 0 Likes
on
0 Posts
I had a similar problem recently. All lights would work. odometer #'s showed up while key was on. But when started they went out and no tach or speedo either. It turned out to be a bent PIN at the white connector that goes from the engine harness to the dash harness. Carrying the signals for tach and such. Maybe check to see that those pins are all OK or that the connector is actually plugged in.
That is a starting point idea from my side anyways. AFter you check the fuses first though. Check the obvious first
That is a starting point idea from my side anyways. AFter you check the fuses first though. Check the obvious first
10-24-04, 10:59 PM
#4
The Laser Man
sometimes its the guage itself... I installed a profec-b on my friends car and everything was wired and working but it wouldn't work.... found out that it was the profec-b itself... a bad part.... it happens not very often but it does happen sometimes. 
