Grounding across frame welds
#1
Grounding across frame welds
Has anyone experimented with the resistance across welds or various parts of the chassis?
Because if a welded joint in the frame were to slowly corrode or get dirty it could build resistance and screw up the grounding plane of the car.
Dave
Because if a welded joint in the frame were to slowly corrode or get dirty it could build resistance and screw up the grounding plane of the car.
Dave
#3
Originally posted by FormerPorscheGuy
you are thinking way too much.
you are thinking way too much.
BTW you should read the old threads on 3k hesitation.
I've got it, and I will improve the engine->frame grounding connections. I'm just wondering if anyone has ever tried checking/improving the frame->frame connections.
This topic is relatively simple compared to the old discussions.
Dave
Last edited by dgeesaman; 03-17-04 at 08:29 AM.
#5
Originally posted by RotorMotor
i suppose you could bridge across welds, but id hope the car isnt to the point where this is a problem
i suppose you could bridge across welds, but id hope the car isnt to the point where this is a problem
Dave
#7
Lives on the Forum
There is no way to test the electrical resistance of the welds because there is no way to isolate them.
And I agree with FormerPorscheGuy; you're thinking way too much
And I agree with FormerPorscheGuy; you're thinking way too much
Trending Topics
#9
PV = nRT
Join Date: Jan 2003
Location: New Zealand (was California)
Posts: 2,250
Likes: 0
Received 0 Likes
on
0 Posts
The resistance from any part of the engine bay to another part of the engine bay, when properly grounded with stock grounds, is so low it's not even worth making an issue about it.
I seem to remember seeing around .1 ohm or around there when testing from the fender to the top of the engine.
I seem to remember seeing around .1 ohm or around there when testing from the fender to the top of the engine.
#12
Originally posted by clayne
The resistance from any part of the engine bay to another part of the engine bay, when properly grounded with stock grounds, is so low it's not even worth making an issue about it.
I seem to remember seeing around .1 ohm or around there when testing from the fender to the top of the engine.
The resistance from any part of the engine bay to another part of the engine bay, when properly grounded with stock grounds, is so low it's not even worth making an issue about it.
I seem to remember seeing around .1 ohm or around there when testing from the fender to the top of the engine.
I will look for any bolted connections though and see if there is significant resistance across them.
Dave
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM