Greddy e-01 boost controller
#1
Rotary Enthusiast
Thread Starter
iTrader: (17)
Join Date: Feb 2001
Location: Pluto
Posts: 878
Likes: 0
Received 0 Likes
on
0 Posts
Greddy e-01 boost controller
My e-01 boost controller has lost its display,as in it does not display anything.All the other components appear normal as far as I can test---ie power on the control unit,signal from pressure sensor OK and solenoid valve is functional.
Greddy have chosen not to answer my e-mail enquiry.Does anyone out there know if this is a common failure?Any tips on where I could send it to be repaired?
Greddy have chosen not to answer my e-mail enquiry.Does anyone out there know if this is a common failure?Any tips on where I could send it to be repaired?
#2
RX-7 Bad Ass
iTrader: (55)
Call Greddy, I seriously doubt they'd respond to an email. And, go through and check the wiring to the unit with a fine tooth comb.
Most likely something happened to it. You MIGHT be able to find just a display used, but that's most likely not happening. You may have to bite the bullet and buy another one.
Dale
Most likely something happened to it. You MIGHT be able to find just a display used, but that's most likely not happening. You may have to bite the bullet and buy another one.
Dale
Thread
Thread Starter
Forum
Replies
Last Post