Good job XS
#1
Full Member
Thread Starter
Join Date: Mar 2001
Location: sunnyvale, Ca
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
Good job XS
Got my P-FC mapped by XS for $150 and it's much nicer. Car runs great and pulls really well. Boost move right up and holds steady. XS was very good and turned it around in one day. They were very persistent in contacting me to resolve the method of return shipment. They even had the lobby page me - almost too persistent but that's better than the opposite. I give them a solid "A".
I get about 88% injector duty cycle max using .85 bar on the P-FC boost setting.
Installed the CWC cold air intake too and finally got a chance to take a few runs out on the freeway this afternoon. Tried to get paper plated 911 to race me but no game.
It pulls from 80 to 120 really strong and fast. It's been since last june since my car has been working right so this was a really good day!
Next it's the intercooler mist controller. It's sitting on it's box in the living room - where all new parts wait .
Data I read on the Audi page showed inlet air temps rose only 2 deg F withthe mister installed and like 18 without. Hey WTF until I can pop $1700 for a IC and piping kit, it's better than nothing.
I get about 88% injector duty cycle max using .85 bar on the P-FC boost setting.
Installed the CWC cold air intake too and finally got a chance to take a few runs out on the freeway this afternoon. Tried to get paper plated 911 to race me but no game.
It pulls from 80 to 120 really strong and fast. It's been since last june since my car has been working right so this was a really good day!
Next it's the intercooler mist controller. It's sitting on it's box in the living room - where all new parts wait .
Data I read on the Audi page showed inlet air temps rose only 2 deg F withthe mister installed and like 18 without. Hey WTF until I can pop $1700 for a IC and piping kit, it's better than nothing.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM